Epson Stylus Pro 7600 - UltraChrome Ink Service Manual - Page 84
Paper feeding adjustment conversion table
View all Epson Stylus Pro 7600 - UltraChrome Ink manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
EPSON Stylus Pro 7600/9600 1.4.6 Paper feeding adjustment conversion table The adjustment conversion table has four 256byte screens in NVRAM. The details are as follows. Table name 1 Pigment user table 2 Dye user table 3 Pigment system table 4 Dye system table Table 1-49. Description For pigment ink media, can be changed by user, 256byte For dye inku media, can be changed by user 256byte For pigment ink media, cannot be changed by user, 256byte For dye ink media, user cannot be changed by user, 256byte Use during printing User table When the conversion mode is ON in the paper feeding adjustment conversion mode (SN 0A), the paper feeding adjustment setting (SN 04) m2 parameter will be media ID and indicate user table address. The value stored in this address is used as the paper feeding adjustment value. However, if the stored value is FFh, the table is divided into three parts as shown below. The m2 parameter of the paper feeding adjustment setting (SN 04) to be used as the paper feeding adjustment value changes depending on the corresponding ID value. 1. 01h ~ 40h Use the value of ID+50h as the paper feeding adjustment value. 2. 41h ~ C0h Use ID as the paper feeding adjustment value. 3. C1h ~ FFh Use the value of ID-64h as the paper feeding adjustment value. NOTE: Designation of pigment/dye depends on ink type setting (NPD setting/IK). System table This table is not used during printing. The manufacture setting value is stored to use as backup for user table. Revision A How to change correction values User table The user table can be changed from the SN menu of Maintenance mode 1. (See "1.4.4 Maintenance Mode 1 (p.66)" for details.) It can be changed by registering the remote commands paper feeding adjustment offset value commands (SN83). It is necessary to save changes (SV). System table The system table can be changed from the Maintenance mode 2 adjustment menu. (See "1.4.5 Maintenance Mode 2 (p.70)" for details.) User table initialization Maintenance mode 1 Selecting "User table initialization" in SN menu allows the user to initialize Maintenance mode 1. Remote commands Setting m2=00h in paper feeding adjustment offset value registration (SN 83) allows the user to initialize remote commands. Product Description Operating Panel 84