HP 2500 HP PCL/PJL reference - Printer Job Language Technical Reference Manual - Page 279

HP LaserJet 5Si Mopier Comments PJL commands are used to specify the destination bin and control printer functions such as stapling and collating multiple copies. Specifying the Output Bin Documents are sent to specific output bins using the @PJL SET OUTBIN command. The HP LaserJet 5Si Mopier bin definitions are as follows: Bin Description OUTBIN Variable Name Engine face-down bin UPPER High Capacity Output (HCO) face-up bin OPTIONALOUTBIN1 Stapling bin (in mailbox mode) OPTIONALOUTBIN7 Stapling bin (in stacker or jobseparator modes) OPTIONALOUTBIN3 First non-stapling bin in mailbox mode (only bin in stacker and job-separator modes) OPTIONALOUTBIN2 Last non-stapling bin (bottom bin in OPTIONALOUTBIN6 mailbox mode) Stapling Documents To staple a document, include the following PJL command in the PJL header at the beginning of the job (see the example on the following page): @@PJL SET FINISH=STAPLE To staple the output using this command, the printer automatically determines which bin is the stapling bin, so the output bin does not need to be specified using the @PJL SET OUTBIN command. The printer uses the EOJ command to determine the end of job so that the job can be stapled correctly. Note Future printers may enable stapling using a different command sequence. EN Product-Specific Feature Support A-57