HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 20
An E_Port isolated because, Shortest Path First FSPF. - review
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1003.0066) (ISL group entry for switch wwn does not contain valid binding configuration. Entry should have binding domain domain_ID) A switch in the fabric is using a domain ID that differs from the configured fabric binding domain ID. Change either the current switch domain ID or the fabric-binding configured domain ID so that they match. (A1003.0069) (Failing remote zoning configuration, invalid zone data received) Zoning activation failed because the switch detected invalid zoning data that is not supported in the local interop mode. Check your zoning configuration and remove incompatible zone members. (A1004.0001) (Port in active hard zone, but not installed or present on this switch.) A zone member in a hard Examine the fabric and zone on this switch is defined correct the zone membership. with an invalid port number. (A1004.0005) (No communication from neighbor switch on port port_number with domain ID domain_ID, lost route) This switch has not received a hello from the remote switch for 80 seconds. The routes learned through this link are discarded. None (A1004.0008) (Eport Isolating due to ELP Incompatibility) An E_Port isolated due to an ELP (Exchange Link Parameter) incompatibility. Review the accompanying alarms for specific cause. (A1004.0009) (Eport Isolating due to ESC Incompatibility) An E_Port isolated because the connecting switch failed to support the standard routing protocol Fabric Shortest Path First (FSPF). Connect a compatible switch. (A1004.000A) (Eport Isolating due to EFP Domain Overlap) An E_Port isolated because Change the domain ID on each fabric has a switch with one of the conflicting the same domain ID. switches. (A1004.000B) (Eport Isolating due to Switch Administratively Offline) An E_Port isolated because the local switch has been placed offline. Configure the administrative state to Online to establish the link. (A1004.000C) (Eport Isolating due to Domain ID Locked, Domain ID unavailable) An E_Port isolated because the requested domain ID matches another in the fabric, and assigning an alternative is prohibited by the DomainIDLock parameter. Disable the DomainIDLock parameter or reconfigure the domain IDs. (A1004.000D) (Eport Isolating due to RDI SW Reject) An E_Port isolated because the principal switch rejected the local switch domain ID. Change the domain ID so that it is unique in the fabric. (A1004.000E) (Eport Isolating due to RDI Domain out of Range) An E_Port isolated because the principal switch rejected the local switch domain ID as being out of range (1-239). Change the domain ID to a valid number that is within the range. 20