HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 41

Table 5 Critical event messages and descriptions (Continued) Icon Event ID and message Description (C) (8400.0049) (Switch) (The Configuration Wizard from ip_address is exiting - switch configuration may have changed) Changes made to switch may result in loss of communication with the switch. (C) (8400.004B) (Switch) (Attempted to license modes on an unsupported switch type) An attempt was made to install a license key for a feature that is not supported on the switch. (C) (8400.004C) (Switch) (Services setup is changing - may lose connection - admin being released automatically) The Services configuration is changing and this may result in the loss of a connection. (C) (8400.004D) (Switch) (ntpdate: no server suitable for synchronization found) The Network Time Protocol (NTP) server was not found. (C) (8400.004E) (Switch) (ntpdate: synchronization lost) The Network Time Protocol (NTP) server synchronization was lost. (C) (8400.0050) (Switch) (Upgrading License allowing manufacturing setup mode capability) The license upgrade was successful. (C) (8400.0052) (Switch) (Upgrading The license upgrade was successful. License for EFCM capability) (C) (8400.0053) (Switch) (The switch The license upgrade was successful. WWN is being upgraded) (C) (8400.0054) (Switch) (radius: All RADIUS servers failed to respond) None of the configured Remote Authentication Dial In User Service (RADIUS) servers responded. Check the RADIUS server configuration. (C) (8400.0057) (Switch) (User login (user_name) is being closed - Telnet connections have been disabled A Telnet session has closed. (C) (8400.0058) (Switch) (User (user_name) is using their initial/default password) The specified user has not changed their password from its initial value. (C) (8400.005B) (Switch) (A nicknames configuration edit session has been canceled) A nicknames edit session was canceled by the user. (C) (8400.005D) (Switch) (Upgrading The SANdoctor bundle license was applied License for SANdoctor) successfully. (C) (8400.005F) (Switch) (Upgrading The Common Information Model (CIM) License for SMI-S capability) license was applied successfully. (C) (8400.0062) (Switch) (New firmware has been installed.) New firmware was successfully installed. (C) (8400.0065) (Switch) (The switch is being automatically hardreset after leaving the Diagnostics AdminState.) The switch automatically undergoes a hard reset after leaving the Diagnostics administrative state. HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message Reference Guide 41