HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 51

Table 7 Informative event messages and descriptions (Continued) Event ID and message (I) (8400.002C) (Switch) (User login session session_ID user account_name has timed out) (I) (8400.0036) (Switch) (Hotreset not permitted at this time, try again later) (I) (8400.0037) (Switch) (VIEnable automatically set to False since MFSEnable has been set to True) (I) (8400.0038) (Switch) (LCFEnable automatically set to False since MFSEnable has been set to True) (I) (8400.0039) (Switch) (MFSEnable automatically set to False since VIEnable has been set to True) (I) (8400.003A) (Switch) (MFSEnable automatically set to False since LCFEnable has been set to True) (I) (8400.003E) (Switch) (Readjusting TempMonitoringWarning from value C to value C) (I) (8400.0040) (Switch) (Readjusting TempMonitoringFailure from value C to value C) (I) (8400.0048) (Switch) (A CIM edit session has been canceled) (I) (8400.008C) (CallHome configuration has changed) (I) (8400.0097) (DNS lookup for host_name failed) (I) (8600.0007) (PortApp) (Port: port_number) (Cancelling Online Test) (I) (8600.001D) (PortID port_fcid PortWWN port_wwn logged into nameserver.) (I) (8600.001E) (PortID port_fcid PortWWN port_wwn logged out of nameserver) (I) (8600.001F) (SYNC_ACQ) (I) (8600.0020) (SYNC_LOSS) Description A user login session has ended because of inactivity. Conditions exist that will not allow a hotreset. Try again later. Setting the set config port command parameter MFSEnable to True automatically sets the set config port command parameters VIEnable and LCFEnable to False. Setting the set config port command parameter MFSEnable to True automatically sets the set config port command parameters VIEnable and LCFEnable to False. Setting the set config port command parameter VIEnable to True automatically sets the set config port command parameter MFSEnable to False. Setting the set config port command parameter LCFEnable to True automatically sets the set config port parameter MFSEnable to False. The temperature threshold at which the switch issues a warning alarm is being changed. The temperature threshold at which the switch issues a failure alarm is being changed. A Common Information Model (CIM) edit session has been cancelled. The Call Home service configuration was changed by the administrator. The specified host name was not found on the Domain Name System (DNS) server. Verify the host name and correct it if necessary. Otherwise, report the failed host name to your network administrator. The online test was canceled. The device given by the port Fibre Channel address and port WWN has logged in to the name server. The device given by the port Fibre Channel address and port WWN has logged out of the name server. The port identified in previous event messages has synchronized with a connected device. The port identified in subsequent event messages has lost synchronization with a connected device. HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message Reference Guide 51