HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 49
Informative events, Fibre, Channel General Services-3
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Informative events Informative events are events that occur in the normal activities of a fabric. Note that there is no icon for Informative events. Table 7 provides the event ID and text of the message along with an explanation of the message. Table 7 Informative event messages and descriptions Event ID and message Description (I) (8200.0001) (mserver) (Hotreset is not permitted at this time, try again later) The switch was busy at the time of the attempted hot reset. Try the hot reset again later. (I) (8200.0002) (mserver) (Port: port_number) (Rejecting request from address FC_address, inband management is disabled on port port_number) A Management Server command was received on a port that is configured to refuse inband management requests. (I) (8200.0100) (mserver) (Cannot map The rieln management server command was number_of_characters characters to Switch processed, and the Interconnect Element Logical Symbolic Name (max number_of_characters)) Name was registered. However, the registered name is of greater length than the maximum length allowed for the Switch Symbolic Name, so therefore the Switch Symbolic Name was not changed to match the registered name. (I) (8200.0101) (mserver) (Cannot map non-printable characters to Switch Symbolic Name) The rieln management server command was processed, and the Interconnect Element Logical Name was registered. However, the registered name contains unprintable characters. These characters are not allowed for the switch symbolic name, therefore the switch symbolic name was not changed to match the registered name. (I) (8200.0200) (mserver) (Rejecting request (GZM) for zone zone_name containing unsupported alias member(s) The fabric zone server command gzm (Get Zone Member) was rejected because the requested zone member was an alias that is not defined in Fibre Channel General Services-3 (FC-GS-3). (I) (8200.0201) (mserver) (Rejecting request command:command) A fabric zone server command was rejected for the reason detailed in the message. This can be caused by two users attempting to configure the switch or zoning database at the same time. Contact your authorized maintenance provider if the reason for the failure is not clear. (I) (8200.0202) (mserver) (Rejecting request (GZS) for zone set zone_set_name containing unsupported alias member(s)) The fabric zone server command gzs (Get Zone Set) was rejected because the requested zone set contains one or more members that are aliases. Since aliases are not defined in FC-GS-3, the request could not be completed. (I) (8200.0300) (mserver) (Cannot register HBA World Wide Name (WWN) device_WWN, FDMI database has reached its configured limit.) The switch contains a database that is configured to allow a certain number of Host Bus Adapters (HBAs) to register Fabric Device Management Interface (FDMI) information with this switch. An HBA has attempted to register its FDMI information with the switch, but allowing it to do so would cause the FDMI database to exceed the configured limit. HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message Reference Guide 49