HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 29
TR_Port or the F/FL port, A Port Login PLOGI - storageworks npiv
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1005.0106) (Fabric translation setup error, PLOGI from fc_id to fc_id OX_ID ox_id rejected) A Port Login (PLOGI) from one transparent route endpoint to another was rejected because of hardware resource limitations on the TR_Port or the F/FL port involved in the mapping. If there are 32 active transparent routes on the TR_Port, reduce the number of mappings on that port, or use a different TR port. If there are 32 active transparent routes on the F/FL_Port, reduce the number of mappings on that port. (A1005.0107) (TR Proxy Login failed: wwn already logged into local fabric at FC-ID fc_id) A proxy for a device in a Examine the HBAs with the remote fabric could not be given WWN and determine created in the name server of which is using the incorrect the local fabric because a world wide name. device with the same port name was already logged in. (A1005.0108) (TR Port internal error encountered) An internal inconsistency was detected by the switch firmware that affected a transparent route. Contact your authorized maintenance provider. (A1005.0109) (TR ignored if_zone and if_zone; port_wwn> shared but two TR ports port_wwn, port_wwn used) The zone set contains inter-fabric zones (IFZ) that shared the same device port name, but uses different TR_Ports on the same switch. Remove one of the inter-fabric zones or modify them so that both zones use the same TR_Port. (A1005.010A) (Remote fabric attached to port does not support NPIV) A TR_Port could not log into a remote fabric because the remote fabric port does not support N_Port ID Virtualization (NPIV). Enable NPIV on the switch attached to the TR_Port, or use a different remote fabric switch port. (A1005.010E) (TR Proxy Login for port_wwn failed: native device with FC-ID fc_id is also a proxy) A transparent route attempted to map a device in the local fabric that is also proxy of a device in a remote fabric. Physically move the device from the remote fabric to the local fabric. (A1005.010F) (PLOGI S_ID fc_id D_ID fc_id OX_ID ox_id, no proxy for destination device on this port) A Port Login (PLOGI) could not be translated because no proxy was found for the destination address. Contact your authorized maintenance provider. (A1005.0110) (PLOGI S_ID fc_id D_ID fc_id OX_ID ox_id, no proxy for source device on this port) A Port Login (PLOGI) could not be translated because no proxy was found for the source address. Contact your authorized maintenance provider. (A1005.0111) (TR Port Name port_wwn found in local fabric, disabling Transparent Routing on this port, check ISL configuration, reset port to retry) The switch connected to the TR_Port is part of the local fabric. Remove the switch attached to the TR_Port from the local fabric or disconnect the TR_Port (transparent routing is not needed to reach devices in the local fabric). HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message Reference Guide 29