HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 33

Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1007.001D) (Ignoring RADIUS Server Radius_Server, invalid IP address configured) A Remote Authentication Dial In User Service (RADIUS) server could not be found at the configured IP address. Check the RADIUS server, or change the configuration to use an IP address for a valid RADIUS server. (A1007.001F) (Access reject from RADIUS server IP_address:port for device on this port) Security authentication has reached the maximum retry count. The port will now isolate. Check the security configuration. (A1007.0020) (MAX Retry count reached on CHAP Authentication Protocol Reset, failing Authentication) A Remote Authentication Dial In User Service (RADIUS) server has rejected a RADIUS authentication request. Check the configuration on both the switch and on the RADIUS server for incompatibilities. (A1007.0021) (No response to RADIUS access request for device on port port) A configured Remote Authentication Dial In User Service (RADIUS) server did not respond to an authentication request within the timeout period. Check RADIUS server configuration and the RADIUS server. (A1007.0022) (Invalid response authenticator from RADIUS server IP_address:port, check shared secret) There is a Remote Authentication Dial In User Service (RADIUS) server configuration issue. Verify that the shared secret is configured on both the RADIUS server and the switch. (A1007.0023) (Invalid response authenticator from RADIUS server IP_address:port, check shared secret There is a Remote Authentication Dial In User Service (RADIUS) configuration problem. Confirm that the shared secret configured on the switch is identical to the shared secret configured on the RADIUS server. (A1007.0024) (Invalid access accept from RADIUS server IP_address:port, bad or missing Service-Type) A service-type Remote Authentication Dial In User Service (RADIUS) attribute was not found in a RADIUS packet. This is a RADIUS server configuration issue. Consult your RADIUS server documentation. (A1007.0025) (Security feature not supported.) The switch is coming out of Non-Disruptive Code Load and Activation (NDCLA) and had an active security prior to the NDCLA, but the security feature is no longer supported. A license key may be required for the security feature. (A1007.0026) (Unable to validate Chap Response from device_WWN, possible Chap secret misconfiguration or security breach attempt.) A Challenge Handshake Authentication Protocol (CHAP) authentication attempt failed due to failure while comparing secrets. Check security configuration. HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message Reference Guide 33