HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 30

Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1005.0112) (PLOGI S_ID fc_id D_ID fc_id OX_ID ox_id rejected during NDCLA) A port login (PLOGI) was received for transparent routing after the Non-Disruptive Code Load and Activation (NDCLA) had begun. An attempt was made to send a reject. Retry the port login after the NDCLA is complete. (A1005.0113) (TR Port removing Proxy for port_wwn logged in at FC-ID fc_id, duplicate port name logged in at FC-ID fc_id) A device is logged in on another switch in the local fabric with the same port WWN as a proxy for a device in a remote fabric. The proxy created on the local switch has been removed. Examine the HBAs with the given WWN and determine which is using the incorrect world wide name. (A1006.0004) (Zoning conflict, device_WWN is in an ACL hard zone, but device_WWN share a soft zone) The named zone members cannot communicate because they are members of different hard zones. Place both zone members in the same hard zone or exclude both from hard zones. (A1006.0005) (Zoning enforcement error in Nameserver) An error occurred while checking hard zoning. Contact your authorized maintenance provider. (A1006.0006) (Zoning conflict, device_WWN and device_WWN do not share an ACL hard zone, but device_WWN share a soft zone) The named zone members cannot communicate because they are members of different hard zones. Place both zone members in the same hard zone or exclude both from hard zones. (A1007.0001) (Security: Unspecified zoning enforcement error) A device was not authorized or it failed security checks and will not be allowed to join the fabric. None (A1007.0002) (Security: Remote Switch with WorldWide Name (WWN) wwn configured for chap, no chap configured for local switch. 2-way Authentication Failure) The device worldwide name (WWN) is either not configured in the security database, or it is not configured for Challenge Handshake Authentication Protocol (CHAP). Add the device WWN to the active security set if it missing, or modify the group to allow for CHAP authentication with the other devices. (A1007.0005) (Security: Authentication request was rejected by port.) Indicates that a remote switch rejected a security authentication attempt. The port will isolate. Checks the security configuration on the remote switch to determine the problem. (A1007.0006) (Security: Could not validate Authentication Response from port_number, payload seems to be incorrect.) The format of the payload of the response frame does not match what was expected. Check for errors on the remote side of the link. Check the transceiver and cable. Update firmware on remote switch. 30