HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 40

Table 5 Critical event messages and descriptions (Continued) Icon Event ID and message Description (C) (8400.0028) (Switch) (Invalid user account_name attempted to log into switch) Invalid user login attempt. (C) (8400.0029) (Switch) (User account_name attempted to log into switch with an incorrect password) Invalid user login attempt. (C) (8400.002A) (Switch) (User account_name attempted to log into switch with an incorrect password) Invalid user login attempt. (C) (8400.002E) (Switch) (number_of_zone_members zone members are being saved - this may take several seconds) It will take several seconds to save the large zoning database. (C) (8400.002F) (Switch) (Zoning database of over 3,000 zone members may damage some vendors' switches, if you have other vendor's switches in your fabric, please refer to their switch manual/documentation to see what zone member limits the switch supports) You have a large database on the switch consisting of over 3,000 zone members. This could cause a problem in mixed fabrics because not all vendors support a configuration this large. (C) (8400.0030) (Switch) (Zoning edit session has been preempted by a zoning merge) A zoning edit session has been preempted by a zone merge. The zoning edit session has been canceled. (C) (8400.003B) (Switch) (Creating the support file - this will take several seconds) The switch is creating a support file. This takes a few seconds to complete. (C) (8400.003C) (Switch) (Network setup is changing - may lose connection - admin being released automatically) Changes made to the network configuration may interrupt your connection to the switch. (C) (8400.0042) (Switch) (Warning deleting the active zoneset may cause fabric isolation) Deleting the active zone set from the zoning database could isolate all switches in the fabric. (C) (8400.0043) (Switch) (Warning clearing the active zoneset may cause fabric isolation) Clearing all zoning definitions from the active zone set could isolate all switches in the fabric. (C) (8400.0044) (Switch) (A reset is required since a Power On Self Test (POST) has never run on these ports) After upgrading ports, it may be necessary to reset the switch so that the Power-on Self Test (POST) can run on the newly licensed ports. (C) (8400.0045) (Switch) (Upgrading License for 20G capability) Installation of the license key that grants 20-Gb/s transmission speed capability to the XPAK ports is in progress. (C) (8400.0046) (Switch) (Upgrading The switch has been upgraded to allow for License for multiple ISL capability) multiple inter-switch links. (C) (8400.0047) (Switch) (New licenses are being installed New licenses are being installed. 40