HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 42

Table 5 Critical event messages and descriptions (Continued) Icon Event ID and message Description (C) (8400.0067) (Switch) (The switch is entering Diagnostics AdminState and will automatically hardreset and have the configured AdminState when leaving the Diagnostics AdminState.) The switch is entering the Diagnostics state and will automatically undergo a hard reset. The switch will return to the configured administrative state after leaving the Diagnostics administrative state. (C) (8400.006A) (Switch) (Upgrading The Fabric Security Bundle license was License for Fabric Security) applied successfully. (C) (8400.006B) (Switch) (Upgrading License for CLI Extended Credits capability) The command line interface (CLI) Extended Credits license was applied successfully. (C) (8400.008A) (A Zoning merge has Two fabrics have been connected and their occurred) zoning databases have been merged. (C) (8400.008D) (Illegal configuration detected based on licensing. Configuration will be updated) The restoration of a configuration backup has violated current feature licensing. The active configuration will be automatically updated based on current licensing. (C) (8400.008E) (Inconsistent configuration defaults detected. Defaults will be updated.) Two fabrics have been connected, and their zoning databases have been merged. (C) (8600.0009) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port port_number.) The port will perform a link reset (LR) due to a loss of credit issue. (C) (8600.000A) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port port_number.) The port will perform a link reset (LR) due to a loss of credit issue. (C) (8600.000B) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port port_number.) The port will perform a link reset (LR) due to a loss of credit issue. (C) (8600.0013) (PortApp) (Invalid vendor data from media device for port port_number) The switch could not read and verify the media module ID. This may indicate a discovery error or a bad checksum in the serial ID. Other possibilities include an improperly installed media module or an internal media I/O hardware fault. (C) (8600.0014) (PortApp) (Invalid vendor data from media device for port port_number) The switch could not read and verify the media module ID. This could be caused by a media discovery error, a bad checksum in the media serial ID, an improperly installed media, or an internal media I/O hardware fault. (C) (8600.0015) (PortApp) (Unresponsive device alpa on port port_number removed from the fabric.) A device on the loop port did not take an OPN primitive off the loop destined for it. This suggests the device either has been physically removed or is faulty. In addition, it has been removed from the fabric nameserver. (C) (8600.0016) (PortApp) (Online port(s) port_numbers were reset due to disruption during hot reset.) The specified ports were reset because of disruptions that occurred during a hot reset operation. 42