HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message R - Page 47
time with the Network Time Protocol NTP, Either both Simple Mail Transfer Protocol
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Table 6 Warning event messages and descriptions (Continued) Icon Event ID and message Description (W) (8400.0034) (Switch) (Port port_number was Downed before hotreset due to excessive errors still DOWNED) A port was disabled by the threshold monitoring application before the hot reset and is still disabled after the hot reset. (W) (8400.0035) (Switch) (Retrying port port_number that was Downed due to excessive errors) A port that was disabled by the threshold monitoring application is periodically being retried to see if the error conditions have been cleared. (W) (8400.003D) (Switch) (Invalid user (user_name) attempted to log into switch) Invalid user login attempt. (W) (8400.007D) (Switch) (ntp: attempting to synchronize to server at ip_address] The switch is attempting to synchronize its time with the Network Time Protocol (NTP) server at the specified IP address. (W) (8700.0009) (EPort) (Port: port_number) (Inter-Switch Link (ISL) communication error) The remote switch has lost the local switch's identity. (W) (8700.000A) (EPort) (Port: port_number) (No response from remote switch, resetting Inter-Switch Link (ISL)) No communication has been received from the remote switch for some time, indicating that it may not be functioning properly. The E_Port will be reset in an attempt to reestablish the ISL. (W) (8B00.000D) (SMTP servers in the CallHome setup are using duplicate IP address and port number pairs) The Call Home service configuration must not duplicate both the Simple Mail Transfer Protocol (SMTP) server IP address and port number values. However, the configuration may duplicate either the server IP address or the port number. For better fault tolerance, the SMTP servers should run on different physical systems. The port number value of 25 is the well-known service number for the SMTP protocol. (W) (8B00.000E) (Message queue is empty, cancelling attempts to retry sending last message) The Call Home service was waiting to resend a message when the message expired or there was a request to clear the queue of all messages. (W) (8B00.000F) (Will retry sending via SMTP server ip_address, port port_number, after seconds seconds) After a communication failure or Simple Mail Transfer Protocol (SMTP) error, the switch attempts to resend the e-mail message using the specified server, port, and delay. (W) (8B00.0010) (Will retry sending via SMTP server ip_address, port port_number) After receiving a transient error from the Simple Mail Transfer Protocol (SMTP) server on an e-mail message sent to a recipient, the Call Home service will attempt to resend the e-mail message. (W) (8B00.0011) (SMTP addresses are defaults or disabled, will not retry sending messages until a valid SMTP address has been configured and enabled) Either both Simple Mail Transfer Protocol (SMTP) server IP addresses in the Call Home service configuration are the default value (0.0.0.0) or they have not been enabled. HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Event Message Reference Guide 47