HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 164

delay (interface) Chapter 2 Ethernet Commands Send comments to [email protected] delay (interface) To set a delay value for an interface, use the delay command. To restore the default delay value, use the no form of this command. delay tens-of-microseconds no delay Syntax Description tens-of-microseconds Specifies the throughput delay in tens of microseconds. Command Default 10 μsec Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Examples The following example shows how to set a delay of 30,000 microseconds on an interface: switch(config)# interface ethernet 1/1 switch(config-if)# delay 3000 Related Commands Command show interface Description Displays the interface configuration information. 2-16 Cisco Nexus 5000 Series Command Reference OL-16599-01