HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 545

Chapter 8 Fibre Channel Commands cfs region Send comments to [email protected] cfs region To create a region that restricts the scope of application distribution to the selected switches, use the cfs region command. To disable this feature, use the no form of this command. cfs region region-id no cfs region region-id Syntax Description region-id Specifies the region identifier. The range is from 1 to 255. A total of 200 regions are supported. Command Default The default region identifier is 0. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines An application can only be a part of one region on a given switch. By creating the region ID and assigning it to an application, the application distribution is restricted to switches with a similar region ID. Cisco Fabric Services (CFS) regions provide the ability to create distribution islands within the application scope. Currently, the regions are supported only for physical scope applications. In the absence of any region configuration, the application will be a part of the default region. The default region is region ID 0. Examples The following example shows how to create a region ID: switch(config)# cfs region 1 The following example shows how to assign an application to a region: switch(config)# cfs region 1 switch(config-cfs-region)# ntp The following example shows how to remove an application assigned to a region: switch# cfs region 1 switch(config-cfs-region)# no ntp Related Commands Command show cfs regions Description Displays all configured applications with peers. OL-16599-01 Cisco Nexus 5000 Series Command Reference 8-11