HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 617
fspf cost
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 617 highlights
Chapter 8 Fibre Channel Commands fspf cost Send comments to [email protected] fspf cost To configure FSPF link cost for an FCIP interface, use the fspf cost command. To revert to the default value, use the no form of the command. fspf cost link-cost vsan vsan-id no fspf cost link-cost vsan vsan-id Syntax Description link-cost vsan vsan-id Enters FSPF link cost in seconds. The range is 1 to 65535. Specifies a VSAN ID. The range is 1 to 4093. Command Default 1000 seconds for 1 Gigabits per second interfaces. 500 seconds for 2 Gigabits per second interfaces. Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines This command is not applicable to virtual Fibre Channel interfaces. FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database, and then chooses the path with a minimal cost. The cost associated with an interface can be changed using the fspf cost command to implement the FSPF route selection. Examples The following example configures the FSPF link cost on an FCIP interface: switch(config)# interface fc 2/1 switch(config-if)# fspf cost 5000 vsan 1 Related Commands Command show fspf interface show interface fc Description Displays information for each selected interface. Displays an interface configuration for a specified Fibre Channel interface. OL-16599-01 Cisco Nexus 5000 Series Command Reference 8-83