HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 628
interface vfc, bind interface ethernet
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 628 highlights
interface vfc Chapter 8 Fibre Channel Commands Send comments to [email protected] interface vfc To configure a virtual Fibre Channel interface on a Cisco Nexus 5000 Series switch, use the interface vfc command. To revert to defaults, use the no form of the command. interface vfc vfc-id bind interface ethernet slot/port description line shutdown [force] switchport mode F no interface vfc vfc-id no bind interface ethernet slot/port no description no shutdown no switchport mode Syntax Description vfc-id Specifies a virtual interface ID. bind interface ethernet Binds the virtual Fibre Channel interface to the specified Ethernet interface. slot/port description line Enters a line of text to describe the interface. shutdown Changes the interface state to administrative down. switchport mode F Specifies the mode of the virtual Fibre Channel interface. Command Default Disabled. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines You can specify a range of interfaces by entering a command with the following example format: interface vfc 1 - 3 , vfc 5 - 7 Use the no shutdown command to enable the interface. Examples The following example enters interface configuration mode for virtual Fibre Channel interface 3: switch(config)# interface vfc 3 8-94 Cisco Nexus 5000 Series Command Reference OL-16599-01