HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 56

exec-timeout Chapter 1 Basic System Commands Send comments to [email protected] exec-timeout To configure the inactive session timeout on the console port or the virtual terminal, use the exec-timeout command. To revert to the default, use the no form of this command. exec-timeout minutes no exec-timeout Syntax Description minutes Number of minutes. The range is from 0 to 525600. A setting of 0 minutes disables the timeout. Command Default Timeout is disabled. Command Modes Terminal line configuration Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines You can configure the console port only from a session on the console port. Examples This example shows how to configure the inactive session timeout for the console port: switch# configure terminal switch(config)# line console switch(config-console)# exec-timeout 30 This example shows how to revert to the default inactive session timeout for the console port: switch# configure terminal switch(config)# line console switch(config-console)# no exec-timeout This example shows how to configure the inactive session timeout for the virtual terminal: switch# configure terminal switch(config)# line vty switch(config-line)# exec-timeout 30 This example shows how to revert to the default inactive session timeout for the virtual terminal: switch# configure terminal switch(config)# line vty switch(config-line)# no exec-timeout 1-34 Cisco Nexus 5000 Series Command Reference OL-16599-01