HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 78
modem init-string
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
modem init-string Chapter 1 Basic System Commands Send comments to [email protected] modem init-string To download the initialization string to a modem connected to the console port, use the modem init-string command. To revert to the default, use the no form of this command. modem init-string {default | user-input} no modem init-string Syntax Description default user-input Downloads the default initialization string. Downloads the user-input initialization string. Command Default The default initialization string is ATE0Q1&D2&C1S0=1\015. Command Modes Terminal line configuration Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines You can configure the console port only from a session on the console port. The default initialization string ATE0Q1&D2&C1S0=1\015 is defined as follows: • AT-Attention • E0 (required)-No echo • Q1-Result code on • &D2-Normal data terminal ready (DTR) option • &C1-Enable tracking the state of the data carrier • S0=1-Pick up after one ring • \015 (required)-Carriage return in octal Use the modem set-string command to configure the user-input initialization string. Examples This example shows how to download the default initialization string to the modem connected to the console port: switch# configure terminal switch(config)# line console switch(config-console)# modem init-string default 1-56 Cisco Nexus 5000 Series Command Reference OL-16599-01