HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 184

name (MST configuration) Chapter 2 Ethernet Commands Send comments to [email protected] name (MST configuration) To set the name of a Multiple Spanning Tree (MST) region, use the name command. To return to the default name, use the no form of this command. name name no name name Syntax Description name Name to assign to the MST region. It can be any string with a maximum length of 32 alphanumeric characters. Command Default None Command Modes MST configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines Two or more switches with the same VLAN mapping and configuration version number are considered to be in different MST regions if the region names are different. Caution Be careful when using the name command to set the name of an MST region. If you make a mistake, you can put the switch in a different region. The configuration name is a case-sensitive parameter. Examples This example shows how to name a region: switch(config)# spanning-tree mst configuration switch(config-mst)# name accounting Related Commands Command show spanning-tree mst configuration spanning-tree mst configuration Description Displays information about the MST protocol. Enters MST configuration mode. 2-36 Cisco Nexus 5000 Series Command Reference OL-16599-01