HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 622
fspf retransmit-interval
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 622 highlights
fspf retransmit-interval Chapter 8 Fibre Channel Commands Send comments to [email protected] fspf retransmit-interval To specify the time after which an unacknowledged link state update should be transmitted on the interface, use the fspf retransmit-interval command. To revert to the default value, use the no form of the command. fspf retransmit-interval seconds vsan vsan-id no spf retransmit-interval seconds vsan vsan-id Syntax Description seconds vsan vsan-id Specifies FSPF retransmit interval in seconds. The range is 1 to 65535. Specifies a VSAN ID. The range is 1 to 4093. Command Default 5 seconds. Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines This command is not applicable to virtual Fibre Channel interfaces. This value must be the same in the ports at both ends of the ISL. Examples The following example specifies a retransmit interval of 6 seconds after which an unacknowledged link state update should be transmitted on the interface for VSAN 1: switch(config)# interface fc 2/1 switch(config-if)# fspf retransmit-interval 6 vsan 1 Related Commands Command show fspf interface show interface fc Description Displays information for each selected interface. Displays an interface configuration for a specified FCIP interface. 8-88 Cisco Nexus 5000 Series Command Reference OL-16599-01