HP Cisco MDS 9120 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 735

Chapter 9 Fibre Channel Show Commands show rscn Send comments to [email protected] show rscn To display Registered State Change Notification (RSCN) information, use the show rscn command. show rscn {event-tov vsan vsan-id | pending vsan vsan-id | pending-diff vsan vsan-id | scr-table [vsan vsan-id] | session status vsan vsan-id | statistics [vsan vsan-id]} Syntax Description event-tov vsan vsan-id pending pending-diff scr-table session status statistics Displays the event timeout value. Specifies a VSAN ID. The range is 1 to 4093. Displays the pending configuration. Displays the difference between the active and the pending configuration. Displays the State Change Registration (SCR) table. Displays RSCN session status. Displays RSCN statistics. Command Default None Command Modes EXEC mode. Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines The SCR table cannot be configured. It is only populated if one or more N ports send SCR frames to register for RSCN information. If the show rscn scr-table command does not return any entries, no N port is interested in receiving RSCN information. Examples The following example displays RSCN information: switch# show rscn scr-table vsan 1 The following example displays RSCN statistics: switch# show rscn statistics vsan 1 The following example shows the RSCN event timeout value configured on VSAN 1: switch# show rscn event-tov vsan 1 The following example shows the difference between the active RSCN configuration and the pending RSCN configuration on VSAN 1: switch# show rscn pending-diff vsan 1 OL-16599-01 Cisco Nexus 5000 Series Command Reference 9-41