HP J7934A HP Jetdirect Administrator's Guide - Page 86

Table 3.4 Telnet Commands and Parameters (8 of 18) TCP/IP Access Control Command Description allow Makes an entry into the host access list stored on the HP Jetdirect print server. Each entry specifies a host or network of hosts that are allowed to connect to the printer. The format is "allow netnum [mask]" where netnum is a network number or host IP address, and mask is an address mask of bits applied to the network number and host address to verify access. Up to 10 access list entries are allowed. If there are no entries, all hosts are permitted access. For example, allow 192.0.0.0 255.0.0.0 allows hosts on network 192. allow 192.168.1.2 allows a single host. In this case, the default mask 255.255.255.255 is assumed and is not required. allow 0 clears the host access list. For additional information, see Chapter 7. TCP/IP Other Command Description syslog-config Enables or disables syslog server operation on the print server: 0 disables, 1 (default) enables. (UDP port 514) syslog-svr The syslog server's IP address in dotted notation. It specifies the server that the HP Jetdirect print server sends syslog messages to. For example, syslog-svr: 192.168.40.1 assigns 192.168.40.1 as the IP address of that server. For more information, see Appendix A. syslog-max Specifies the maximum number of syslog messages that can be sent by the HP Jetdirect print server on a per-minute basis. This setting allows administrators to control the log file size. The default is 10 per minute. If it's set to zero, the number of syslog messages is not restricted. syslog-priority Controls the filtering of syslog messages sent to the syslog server. The filter range is 0 to 8, with 0 being the most specific and 8 the most general. Only messages that are lower than the filter level specified (or higher in priority) are reported. The default setting is 8, where messages of all priorities are sent. If 0, all syslog messages are disabled. syslog-facility A code used to identify the source facility of a message (for example, to identify the source of selected messages during troubleshooting). By default, the HP Jetdirect print server uses LPR as the source facility code, but local user values of local0 through local7 can be used to isolate individual or groups of print servers. ENWW TCP/IP Configuration 86