HP J7934A HP Jetdirect Administrator's Guide - Page 91
Table 3.4, Telnet Commands and Parameters 13 of 18, TCP/IP Configuration 91
UPC - 829160279466
View all HP J7934A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Table 3.4 Telnet Commands and Parameters (13 of 18) set-cmnty-name Specifies a password that determines which SNMP SetRequests (control functions) the HP Jetdirect print server will respond to. The community name of an incoming SNMP SetRequest must match the print server's "set community name" for the print server to respond. (For additional security, you may limit configuration access through the print server's host access list.) Community names must be ASCII characters. The maximum length is 255 characters. default-get-cmnty Enables or disables the default Get community name. 0 disables, 1 (default) enables. Disabling this parameter may prohibit communications with SNMP management applications. SNMP Traps Command Description auth-trap Configures the print server to send (on) or not send (off) SNMP authentication traps. Authentication traps indicate that an SNMP request was received, but the community name check failed. 0 is off, 1 (default) is on. trap-dest Enters a host IP address into the HP Jetdirect print server's SNMP trap destination list. The command format is: trap-dest: ip-address [community name] [port number] The default community name is 'public'; the default SNMP port number is '162'. The port number cannot be specified without a community name. To delete the table, use 'trap-dest: 0'. If the list is empty, the print server does not send SNMP traps. The list may contain up to three entries. The default SNMP Trap Destination List is empty. To receive SNMP traps, the systems listed on the SNMP trap destination list must have a trap daemon to listen to those traps. IPX/SPX Command Description ipx-config Enables or disables IPX/SPX protocol operation on the print server. 0 disables, 1 (default) enables. For example, ipx-config 0 will disable IPX/SPX operation. ipx-unitname (Print Server Name) A user-assigned alphanumeric name assigned to the print server (31 characters maximum). By default, the name will be NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware address. Address (Read-only parameter) Identifies the IPX network and node numbers detected on the network, in the form NNNNNNNN:hhhhhhhh (hexadecimal), where NNNNNNNN is the network number and hhhhhhhh is the LAN hardware address of the print server. ENWW TCP/IP Configuration 91