HP ProLiant 4500 Compaq ProLiant 4500R Rack-Mountable Servers Maintenance and - Page 48

Table 3-5, Parallel Printer Test Error Codes

Get HP ProLiant 4500 PDF manuals and user guides View all HP ProLiant 4500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 48 highlights

3-16 Diagnostic Tools Error Code 401-xx 402-xx 403-xx 498-xx Table 3-5 Parallel Printer Test Error Codes Description Printer failed or not connected Printer data register failed Printer pattern test failed Printer failed or not connected Recommended Action The following steps apply to error codes 401-xx through 498-xx: 1. Connect the printer and re-test. 2. Check the power to the printer and re-test. 3. Install the loopback connector and re-test. 4. Check the switch on the Serial/Parallel Interface board (if applicable) and re-test. 5. Replace the Serial/Parallel Interface board (if applicable) and re-test. 6. Replace the system board and re-test. Maintenance and Service Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
3-16
Diagnostic Tools
Maintenance and Service Guide
Table 3-5
Parallel Printer Test Error Codes
Error
Code
Description
Recommended Action
401-xx
402-xx
403-xx
498-xx
Printer failed or not connected
Printer data register failed
Printer pattern test failed
Printer failed or not connected
The following steps apply to error
codes 401-xx through 498-xx:
1.
Connect the printer and re-test.
2.
Check the power to the printer
and re-test.
3.
Install the loopback connector
and re-test.
4.
Check the switch on the
Serial/Parallel Interface board (if
applicable) and re-test.
5.
Replace the Serial/Parallel
Interface board (if applicable)
and re-test.
6.
Replace the system board
and re-test.