HP StorageWorks 1606 HP StorageWorks Fabric OS 6.3.0c Release Notes (5697-0361 - Page 63
FICON FCIP Acceleration error - FCCU LinkBusy from non-Busy CU in, FID 128, Nept_74
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Detected termination of zoned observed running repeated multiple zone updates for several hours in different FIDs. Fixed in Fabric OS 6.3.0 FICON FCIP Acceleration error - FCCU LinkBusy from non-Busy CU in Fixed in Fabric OS 6.3.0 ReadStates. Found 2 LUNs got disabled with "Rekey done with failure" after overnight manual_rekey finished. [CVLC-1001], 775/57, SLOT 2 | FID 128, Nept_74, Manual re-key failed, LUN SN. Fixed in Fabric OS 6.3.0 Workaround prior to code change: Re-enable LUN. With Safezoning disabled, enabling defaultzoning via WT post concerning messages that Safezoning was disable and defaultzoning was Fixed in Fabric OS 6.3.0 enabled. If second FDISC comes in before the switch responds to the first FDISC between the same pair of devices, the Access Gateway daemon Fixed in Fabric OS 6.3.0 panics. In WebTools, for Add operation in VLAN in CEE tab, all created data Fixed in Fabric OS 6.3.0 is not added in the table. FCAP works only in Non-VF mode or VF mode with Default Switch. Fixed in Fabric OS 6.3.0 Unexpected software call traceback error messages are being displayed on the console. Fixed in Fabric OS 6.3.0 DC SAN Director standby CP may reboot due to ASSERT - Failed expression: new_snode != NULL if the chassis have 6-port 10Gb FC ISL Fixed in Fabric OS 6.3.0 blade. When the Ethernet connectivity goes down for about 5 seconds, an Encryption SAN Switch in an hacluster encounters a "VERIFY Failed expression" and ffdc is generated. Fixed in Fabric OS 6.3.0 Supportsave: USB: interactive mode stores all files illegally in switch Fixed in Fabric OS 6.3.0 root directory instead of the USB device. Port Admin: Port Binding should disable 'Auto Mode' when the port is part of a 256 area type that does not support auto mode. Fixed in Fabric OS 6.3.0 Data miscompare seen when the data is written using a KV key, and read using a cache key. Fixed in Fabric OS 6.3.0 Workaround prior to code change: Disable the DEK cache and always use the key vault. Overnight run of hafailover test in large fabric caused a panic on Fixed in Fabric OS 6.3.0 DC SAN Director. QoS can be disabled on ports on 4Gb platforms, but then it cannot Fixed in Fabric OS 6.3.0 later be reenabled to run QoS. Port Admin : Port Swap does not warn the user the ports will be disabled. Fixed in Fabric OS 6.3.0 If switches in an edge fabric have the Principal Priority set to non-default values, updating firmware on the FCR switch may result in fabric reconfiguration and momentary traffic disruption. Fixed in Fabric OS 6.3.0 Workaround prior to code change: Do not set the principal priority of switches in edge fabric to non default value in a routed MetaSANs. HP StorageWorks Fabric OS 6.3.0c Release Notes 63