HP StorageWorks 1606 HP StorageWorks Fabric OS 6.3.0c Release Notes (5697-0361 - Page 70

Zoning fails with Transaction Commit failed. Reason code 2 (26) - Aca was rejected: Remote Switch Busy, Retry in a few seconds error when E_Port to neighboring Mi10k is lost during a zone push operation when in interop mode. Fixed in Fabric OS 6.3.0a I/O traffic with 1606 Extension SAN Switch or Multiprotocol Extension Blade unable to run across edge-to-edge topology when compression Fixed in Fabric OS 6.3.0a and FastWrite are enabled in certain Virtual Fabric configurations. SFP power-supply values are not displayed correctly after doing a nondisruptive firmware upgrade to Fabric OS 6.2.1. Fixed in Fabric OS 6.3.0a Workaround prior to code change: Execute the command again to obtain the correct values. FCIP tunnel may bounce up and down in an impairment network configuration with compression enabled and highly compressible data I/O with either the 1606 Extension SAN Switch or Multiprotocol Extension Blade. Fixed in Fabric OS 6.3.0a With either the 1606 Extension SAN Switch or Multiprotocol Extension Blade, VE tunnel did not come up due to configuration mismatch for tape pipelining. One side shows Write only and the other side shows Write/Read. Fixed in Fabric OS 6.3.0a High CPU load from DCFM performing supportsave causes port to Fixed in Fabric OS 6.3.0a go offline with laser FLT/link reset. Name server database counts do not match for Fabric OS (6.2.1) and M-EOS (9.9.0) switches in the same fabric, so host cannot see the device. This occurs when an HBA capable of a FDMI Register HBA (RHBA) command and M-EOS switch are in the same fabric. Fixed in Fabric OS 6.3.0a Switch panic triggered by size-64 kernel message buffer being used up in virtual fabric with logical ISL configured. Fixed in Fabric OS 6.3.0a Workaround prior to code change: Configure only DISLs between switches. During factory install, configdownload does not download some of the FCoE settings in Fabric OS 6.3.0. This issue pertains to the factory only and will not be encountered in the field. Fixed in Fabric OS 6.3.0a Port reference provided to FICON host by Director History Buffer incorrectly references port address rather than port number. This can cause Fixed in Fabric OS 6.3.0a the host to reference the wrong port. With Fabric OS 6.2, B-series switch in interopmode 3 experiences an Fixed in Fabric OS 6.3.0a NSD panic with C-series switch in interop mode. Transient detected error on internal link caused 8-Gb blade to be faulted with reason=5. Fixed in Fabric OS 6.3.0a Workaround prior to code change: Use slotpoweroff and slotpoweron to clear the fault. After downgrading to 6.2.0x from 6.3.0, when you execute the fwconfigure --eport --ST command runs, the threshold will be set to 63, which is not allowed in Fabric OS 6.2. Fixed in Fabric OS 6.3.0a 70