HP t505 Administrator Guide 5 - Page 29
Configuring VPN settings, Configuring HP Velocity, Customization Center
View all HP t505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
When configuring an IPSec rule, use the General tab to set the rule's information, addresses, and authentication method. The Source Address is the IP address of the thin client, and the Destination Address is the IP address of the system that the client is going to communicate with. NOTE: Only the PSK and Certificate authentication types are supported. Kerberos authentication is not supported. Use the Tunnel tab to configure settings for tunnel mode. Use the Phase I and Phase II tabs to configure advanced security settings. The settings should be the same for all peer systems that communicate with each other. NOTE: An IPSec rule can also be used to communicate with a computer running Windows. Configuring VPN settings HP ThinPro supports two types of VPN: ● Cisco ● PPTP Enable the Auto Start option to start the VPN automatically. Note the following about creating a VPN using Cisco: ● The Gateway is the gateway's IP address or hostname. ● The Group name and Group password are the IPSec ID and IPSec password. ● The Domain setting is optional. ● The User name and User password are the user credentials that have rights to create a VPN connection on the server side. ● The Security Type should be set the same as it is on the server side. Note the following about creating a VPN using PPTP: ● The Gateway is the gateway's IP address or hostname. ● The NT Domain setting is optional. ● The User name and User password are the user credentials that have rights to create a VPN connection on the server side. Configuring HP Velocity Use the HP Velocity tab to configure HP Velocity settings. Go to http://www.hp.com/go/velocity for more information about the HP Velocity modes. Customization Center To open the Customization Center: ▲ Select Setup > Customization Center in the Control Panel. The button at the top of the Desktop page can be used to switch between the ThinPro and Smart Zero configurations. See Comparison of ThinPro and Smart Zero on page 1 for more information about the differences between the two configurations. Customization Center 17