Icom IC-R6 Instruction Manual - Page 11
Programmed scan operation - programming
View all Icom IC-R6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Quick reference guide QUICK REFERENCE GUIDE ■ Programmed scan operation 25 pairs (50 channels) of scan edge memories, specify the scanning ranges, are used for programmed scan operation. The programmed scan scans between the frequencies in channels "xxA" and "xxB" (xx=00 to 24). Therefore, before operating the programmed scan, different frequencies must be programmed into "A" and "B" scan edge channels. D Programming scan edges A start frequency must be programmed into a "xxA," and an end frequency must be programmed into a "xxB" memory channel. 1. Setting frequency In the VFO mode, set a desired receive frequency and receive mode. • When the " mode. " icon is displayed, push [V/M] to select the VFO 2. Selecting a scan edge "A" channel Hold down [S.MW](V/M) for 1 second, then rotate [DIAL] to select one of the 25 scan edge "A" channels. • The " " icon and scan edge channel number blink. 3. Writing a scan edge channel Hold down [S.MW](V/M) for 1 second until 3 beeps sound. • The paired scan edge "B" channel is automatically selected if you continue to hold down [S.MW](V/M) after programming. • When programming is completed, return to the VFO mode. 4. Setting frequency In the VFO mode, set a desired receive frequency. 5. Selecting a scan edge "B" channel Hold down [S.MW](V/M) for 1 second, then rotate [DIAL] to select one of the 25 scan edge "B" channels. • The " " icon and the scan edge channel number blink. • When the scan edge "B" channel is already selected in step 3, (by holding down [S.MW](V/M) after programming), skip this step. 6. Writing a scan edge channel Hold down [S.MW](V/M) for 1 second until 3 beeps sound. • The next scan edge "A" channel is automatically selected if you continue to hold down [S.MW](V/M) after programming. • When programming is completed, return to the VFO mode.