Icom IC-R6 Instruction Manual - Page 53
DVFO scan watch
View all Icom IC-R6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
PRIORITY WATCH 7 D VFO scan watch q Select the channel(s) to be watched. For a memory channel watch: Select a desired memory channel. For a memory scan watch: ➥ Push [V/M] to select the memory mode. ➥ Hold down [SCAN](MODE) for 1 second to enter the scan type selection mode. ➥ Rotate [DIAL] to select a desired scan type, then push [SCAN](MODE) again to start the memory/bank scan. w Hold down [SET](TS) for 1 second to enter the Set mode. e Rotate [DIAL] to select the priority watch set item. r W hile holding down [FUNC], rotate [DIAL] to select "ON." • Select "BELL" if the priority beep function is desired. i Push [SCAN](MODE) to start the VFO scan watch. • The receiver checks the memory channel(s) every 5 seconds. • The watch resumes according to the selected scan resume setting. (p. 37) During a VFO scan watch 7 Searches the VFO frequencies for 5 seconds. Pauses on a memory channel when a signal is received. During a VFO scan watch with the priority beep After 1 sec. t Push [SET](TS) to exit the Set mode and start the watch. • The "PRIO" icon appears. y H old down [SCAN](MODE) for 1 second to enter the scan type selection mode. u R otate [DIAL] to select a desired scan type from "ALL," "BAND," "P-LINK x (x= 0 to 9)" or "PROGxx (xx= 0-24)." A beep tone sounds and the "S" icon blinks when a signal is received on a memory channel. o Push [SET](TS) to cancel the watch and scan. 40