Icom IC-R6 Instruction Manual - Page 37

MEMORY CHANNELS 5 ■ Copying memory contents This function copies a memory channel's contents to the VFO (or another memory channel). This is useful when searching for signals around a memory channel frequency and for recalling the frequency offset, subaudible tone frequency etc. D MemoryVFO q Select the memory channel to be copied. ➥ Push [V/M] to select the memory mode, then rotate [DIAL] to select a desired channel. • If desired, push [BAND] repeatedly to select a desired bank group, then rotate [DIAL] to select a desired bank channel. w H old down [S.MW](V/M) for 1 second to enter the select memory write mode. • 1 short and 1 long beep sounds. • The " " icon and memory channel number blink. e Rotate [DIAL] to select "VF." r H old down [S.MW](V/M) for 1 second to write the selected channel contents into the VFO. • The VFO mode is automatically selected. Holding down [S.MW](V/M) for 2 seconds in step w will also copy the memory contents to the VFO. In that case, steps e and r are not necessary. D Memorymemory 5 q Select the memory channel to be copied. ➥ P ush [V/M] to select the memory mode, then rotate [DIAL] to select a desired channel. w H old down [S.MW](V/M) for 1 second to enter the select memory write mode. • 1 short and 1 long beep sounds. • The " " icon and memory channel number blink. • Do not hold down [S.MW](V/M) for more than 2 seconds. Otherwise the memory contents will be copied to the VFO. e Rotate [DIAL] to select the target memory channel. r H old down [S.MW](V/M) for 1 second again to copy. [EXAMPLE]: Copying channel 20 to 51. Select the memory channel Hold down for 1 sec. Rotate . Hold down for 1 sec. to program. 24