Icom IC-R6 Instruction Manual - Page 78

11 CONTROL COMMAND ■ Command table Cmd. 00 01 03 04 05 06 11 12 14 15 16 Sub Cmd. 01 03 01 02 43 4B Data see the right 02, 05, 06 see the right 02, 05, 06 see the right 02, 05, 06 00/10 00/01 see p. 66 see p. 66 00/01 see p.66 00, 01, 02 00, 01, 02 Description Send frequency data for transceive Send mode data for transceive 02=AM, 05=FM, 06=WFM Read operating frequency Read operating mode 02=AM, 05=FM, 06=WFM Set operating frequency Operating mode selection 02=AM, 05=FM, 06=WFM Send/read the attenuator function setting 00=OFF, 10=ON (approx. 10dB) Send/read ANT selection 0.495 to 1.620 MHz band: 00=EXT, 01=BAR* *"BAR" can only be selected in AM mode. Other frequency band: 00=EXT, 01=EAR Send/read the volume level Send/read the squelch level Read the squelch status 00=Squelch close, 01=Squelch open Read the S-meter level Send/read the tone squelch setting 00=OFF, 01=TSQL, 02=TSQL-R Send/read the DTCS squelch setting 00=OFF, 01=DTCS, 02=DTCS-R 65 Sub Cmd. Cmd. 16 4C 19 00 1A 00 1B 01 02 Data 00/01 00/01 see p. 66 see p. 66 Description Send/read the VSC function setting 00=OFF, 01=ON Read the receiver ID Send/read the AF filter setting 00=Filter OFF, 01=Filter ON Set/read TSQL tone frequency Set/read DTCS code with polality D Data content description • Receive frequency (Command: 00, 03, 05) q w e r XXXXXXXX t XX 10 Hz digit: 0, 5* (depending on 100 Hz) 1 Hz digit: 0 (Fixed) 1 kHz digit: 0-9 100 Hz digit: 0, 2, 5, 7 100 kHz digit: 0-9 10 kHz digit: 0-9 10 MHz digit: 0-9 1 MHz digit: 0-9 1000 MHz digit: 0, 1 100 MHz digit: 0-9 When the tuning step is selected 8.33 kHz (Air band), 100 Hz digit, 10 Hz digit and 1 Hz digit can be set 3 or 6. * 0: When 100 Hz digit is 0 or 5, 5: When100 Hz digit is 2 or 7