Kyocera FS 1020D FS-1020D Operation Guide Rev 1.4 - Page 54
Adhesive-Backed Labels, Table 4-4 - parts list
View all Kyocera FS 1020D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Special Paper 4.3.2 Adhesive-Backed Labels The basic rule for printing on adhesive labels is that the adhesive must never come into contact with any part of the printer. Adhesive paper sticking to the drum or rollers will damage the printer. Label paper must be manually fed. Label paper has a structure comprising of three layers, as shown in Table 4-4 on page 4-8. The top sheet is printed on. The adhesive layer consists of pressuresensitive adhesives. The carrier sheet (also called the linear or backing sheet) holds the labels until use. Due to the complexity of its composition, adhesive-backed label paper is particularly likely to give trouble in printing. Figure 4-1 Top sheet (white bond paper) Adhesive Carrier sheet Adhesive label paper must be entirely covered by its top sheet, with no spaces between the individual labels. Labels with spaces in between are apt to peel off, causing serious paper jam problems. Some label paper is manufactured with an extra margin of top sheet around the edge. Do not remove the extra top sheet from the carrier sheet until after printing is finished. Acceptable Unacceptable Top sheet Carrier sheet Figure 4-2 Table 4-4 lists the specifications for adhesive label paper. Item Weight of top sheet Composite weight Thickness of top sheet Composite thickness Moisture content Table 4-4 Specification 44 to 74 g/m2 (12 to 20 lb/ream) 104 to 151 g/m2 (28 to 40 lb/ream) 0.086 to 0.107 mm (3.9 to 4.2 mils) 0.115 to 0.145 mm (4.5 to 5.7 mils) 4 to 6% (composite) 4-8