Home » Kyocera Manuals » Laser Printers » Kyocera FS 1020D » Manual Viewer

Kyocera FS 1020D FS-1020D Operation Guide Rev 1.4 - Page 74

A.4 Network Interface Card, If the serial interface board kit is installed

Add to My Manuals
Save this manual to your list of manuals

Page 74 highlights

Network Interface Card A.4 Network Interface Card If the serial interface board kit is installed, remove it to use the network interface card. Note Insert the option network interface card into the option interface slot at the rear of the printer. The network interface card enables the printer to be used in a network. 1 Turn off the printer and disconnect the power cord and printer cable. 2 Remove the two screws from the option interface slot cover and remove the slot cover. Option Interface Slot Cover Screws Figure A-15 3 Insert the network interface card and secure it with the screws removed in step 2. Network Interface Card Screws Figure A-16 A-10

Section	Page
Contents	5
Introduction	8
Guide to the Manuals	9
Guide to the Operation Guide	10
Basic Operations	11
1.1 Operator Panel	12
1.1.1 Indicators	13
1.1.2 Keys	13
Maintenance	17
2.1 Toner Container Replacement	18
2.1.1 Toner Container Replacement Interval	18
2.1.2 Replenishing Toner	19
2.2 Cleaning the Printer	22
2.2.1 Printer Interior	22
Troubleshooting	26
3.1 General Guide for Troubleshooting	27
3.2 Print Quality Problems	28
3.3 Indicators	31
3.3.1 Maintenance Messages	32
3.3.2 Errors Requiring Service Personnel Attention	34
3.3.3 Error Messages	37
3.3.4 Normal Indicator Display	39
3.4 Paper Jam Removal	40
3.4.1 Jam at the Face-down Tray and the Rear Cover	40
3.4.2 Jam at the Paper Cassette	41
3.4.3 Jam at the Duplexer	41
3.4.4 Jam Inside the Printer	43
3.4.5 Jam at the MP Tray	44
Paper Selection	47
4.1 General Guidelines	48
4.1.1 Paper Availability	48
4.1.2 Paper Specifications	48
4.2 Selecting the Right Paper	49
4.3 Special Paper	53
4.3.1 Transparency (overhead projection film)	53
4.3.2 Adhesive-Backed Labels	54
4.4 Paper Type	57
Fonts	58
5.1 Internal Fonts	59
5.2 List of Fonts	60
5.2.1 Internal Scalable and Bitmap Fonts and KPDL Fonts	60
Options	65
A.1 Available Options	66
A.2 Expansion Memory Installation	67
A.3 Memory (CompactFlash) Card	72
A.4 Network Interface Card	74
Host Computer Interface	75
B.1 Parallel Interface	76
B.1.1 Parallel Interface Communication Modes	76
B.1.2 Interface Signals	76
B.2 USB Interface	80
B.2.1 Specifications	80
B.2.2 Interface Signals	80
B.3 Serial Interface (Option)	81
B.3.1 RS-232C Interface	81
B.4 RS-232C Protocol	83
B.4.1 PRESCRIBE FRPO D0 Command	84
B.5 RS-232C Cable Connection	85
B.5.1 Obtain a Suitable RS-232C Cable	85
B.5.2 Connecting the Printer to the Computer	85
Printer Specifications	88
C.1 Printer Specifications	89
Glossary	91