Kyocera TASKalfa 3051ci Printing System (11),(12),(13),(14) Color Printing Gu - Page 47
Adding custom calibration sets, Adding custom calibration sets and output profiles
View all Kyocera TASKalfa 3051ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
CALIBRATION 47 Adding custom calibration sets If you are printing on a paper that is similar to the recommended paper but uses different print settings, you might still be able to use the output profile, but you must create a custom calibration set. If the color quality is sufficient, you do not need to create a custom profile (see scenario 3 in the table under "Using the output profiles and calibration sets" on page 45). You can add a new calibration set that you can then select when performing calibration. You can delete a custom calibration set. You cannot delete a factory-supplied calibration set. For instructions on adding a custom calibration set, see Command WorkStation Help. Adding custom calibration sets and output profiles If you determine that none of the factory-supplied output profiles yields acceptable color with your paper, you must create a custom calibration set in Calibrator and a custom profile using profile-generating software such as Fiery Color Profiler Suite (see scenario 4 in the table under "Using the output profiles and calibration sets" on page 45). NOTE: Before creating a custom calibration set and custom output profile, make sure that the copier is calibrated (if calibration is supported on the copier). For information about performing copier calibration, see the documentation that accompanies the copier. Calibration on the E100 requires that each output profile contains a calibration target. If you use Fiery Color Profiler Suite to create a custom output profile, you do not have to perform any procedures to add a calibration target to the output profile. Color Profiler Suite can create a profile that contains a calibration target. • First, create a custom calibration set using Calibrator in Command WorkStation. • Next, create a custom output profile using Color Profiler Suite and install it on the E100.