Lenovo J105 Hardware Maintenance Manual - Page 104
Completing
View all Lenovo J105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Attention: Do not drop anything onto the microprocessor socket while it is exposed. The socket pins must be kept as clean as possible. 12. To install the microprocessor on the new system board, position the microprocessor so that the small triangle 1 is aligned with the corresponding triangle on the socket. 13. Make sure that the small handle that secures the microprocessor is fully open. 14. Using the vacuum pen 1 to pick up the microprocessor, lower the microprocessor straight down into the socket. 15. Lower and latch the handle to secure the microprocessor in the socket. 16. Install the heat sink and fan assembly on the system board. 17. Install the new system board into the chassis and align the screw holes with those in the chassis. Insert and tighten the screws that secure the system board. 18. Connect all the cables to the system board. See "Identifying parts on the system board" on page 85 19. Go to "Completing the FRU replacement." on page 111. 98 Lenovo 3000 J Series