Lenovo J105 Hardware Maintenance Manual - Page 126
Replacing, memory, module
View all Lenovo J105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
4. Slide the drive bay assembly forward until it stops. Disconnect the power supply and signal cables from the drives. Pivot the rear of the drive bay assembly upward to remove it completely from the computer. Note: To allow easier access to the cables, lift the fan plenum off the heat sink. See "Locations" on page 115. 5. Reverse this procedure to replace the drive bay assembly and bezel. Replacing a memory module 1. Remove the cover. See "Removing the cover" on page 114. 2. Remove the drive bay assembly. See "Removing and replacing the drive bay assembly" on page 119. 3. Locate the memory connectors. See "Identifying parts on the system board" on page 116. 4. Open the retaining clips and remove the failing memory module. 120 Lenovo 3000 J Series