Linksys SPA921 Cisco SPA9000 Voice System Administration Guide - Page 106
Configuring the SPA400 Network Connection, IP Subnet Mask, Gateway IP Address
UPC - 745883570799
View all Linksys SPA921 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Administering the SPA400 and Voice Mail Service Configuring the SPA400 Network Connection 5 Configuring the SPA400 Network Connection The SPA400 becomes a DHCP client of any server on the network. The recommended setting is to use a static IP address. This configuration provides ease of installation and prevents connectivity issues that would occur if the IP address of the SPA400 changed. STEP 1 Start Internet Explorer, and enter the IP address of the SPA400. NOTE By default, the SPA400 is configured to obtain an IP Address via DHCP. You can check the obtained IP address on the router DHCP server's client list. STEP 2 When the password prompt appears, enter the default user name, Admin, with no password. Then click OK. NOTE The user name must be entered exactly as shown: Admin. For information about access, refer to "Managing Access to the SPA400 Web-Based Configuration Utility," on page106. STEP 3 Click Setup tab > Basic Setup. STEP 4 Enter the following settings: Network Setup section: • Fixed IP address: Click the radio button, and then enter a valid IP address. NOTE To avoid addressing conflicts, enter an IP address that is outside the range of addresses that are automatically assigned by your DHCP server. • IP Subnet Mask: Enter the subnet mask for the subnetwork that the SPA400 is on. • Gateway IP Address: Enter the IP address of the router for this subnetwork. SPA9000 Voice System Administration Guide 104