Linksys SPA921 Cisco SPA9000 Voice System Administration Guide - Page 232
Call Back Retry Intvl, Interdigit Long Timer
UPC - 745883570799
View all Linksys SPA921 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
SPA9000 Field Reference Voice tab B Call Back Retry Intvl Call Back Delay VMWI Refresh Intvl Interdigit Long Timer Interdigit Short Timer CPC Delay Call back retry interval in seconds. Range: 0-255 seconds. Default: 30 Delay after receiving the first SIP 18x response before declaring the remote end is ringing. If a busy response is received during this time, the SPA9000 still considers the call as failed and keeps on retrying. Default: .5 Interval between VMWI refresh to the CPE. Default: 0 Long timeout between entering digits when dialing. The interdigit timer values are used as defaults when dialing. The Interdigit_Long_Timer is used after any one digit, if all valid matching sequences in the dial plan are incomplete as dialed. Range: 0-64 seconds. Default: 10 Short timeout between entering digits when dialing. The Interdigit_Short_Timer is used after any one digit, if at least one matching sequence is complete as dialed, but more dialed digits would match other as yet incomplete sequences. Range: 0-64 seconds. Default: 3 Delay in seconds after caller hangs up when the SPA9000 starts removing the tip-and-ring voltage to the attached equipment of the called party. Range: 0-255 seconds. SPA9000 has had polarity reversal feature since release 1.0 which can be applied to both the caller and the callee end. This feature is generally used for answer supervision on the caller side to signal to the attached equipment when the call has been connected (remote end has answered) or disconnected (remote end has hung up). This feature should be disabled for the called party (in other words, by using the same polarity for connected and idle state) and the CPC feature should be used instead. Without CPC enabled, reorder tone is played after a configurable delay. If CPC is enabled, dial tone is played when tip-to-ring voltage is restored Resolution is 1 second. Default: 2 SPA9000 Voice System Administration Guide 230