Linksys SPA922 Cisco SPA9000 Voice System Administration Guide - Page 231
Ring and Call Waiting Tone Spec Control Timer Values sec Hook Flash Timer Min
UPC - 745883570836
View all Linksys SPA922 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
SPA9000 Field Reference Voice tab B Voice tab > Regional page Ring and Call Waiting Tone Spec section Ring Waveform Ring Frequency Ring Voltage CWT Frequency Waveform for the ringing signal: Sinusoid or Trapezoid. Default: Trapezoid Frequency of the ringing signal. Valid values are 10-100 (Hz). Default: 0 Ringing voltage. 60-90 (V). Default: 85 Frequency script of the call waiting tone. All distinctive CWTs are based on this tone. Default: 440@-10 Voice tab > Regional page Control Timer Values (sec) section Hook Flash Timer Min Hook Flash Timer Max Callee On Hook Delay Reorder Delay Call Back Expires Minimum on-hook time before off-hook qualifies as hookflash. Less than this the on-hook event is ignored. Range: 0.1- 0.4 seconds. Default: .1 Maximum on-hook time before off-hook qualifies as hookflash. More than this the on-hook event is treated as on-hook (no hook-flash event). Range: 0.4-1.6 seconds. Default: .9 Phone must be on-hook for at this time in sec before the SPA9000 tears down the current inbound call. It does not apply to outbound calls. Range: 0-255 seconds. Default: 0 Delay after far end hangs up before reorder tone is played. 0 = plays immediately, inf = never plays. Range: 0-255 seconds. Default: 5 Expiration time in seconds of a call back activation. Range: 0- 65535 seconds. Default: 1800 SPA9000 Voice System Administration Guide 229