Yamaha RX V1700 MCXSP10 Manual - Page 101

ADVANCED OPERATION p p p 4 OPTION MENU Use this menu to adjust the optional system parameters. 4 OPTION MENU 1/2 . A)DISPLAY SET B)MEMORY GUARD C)AUDIO SELECT D)DECODER MODE [ ]/[ ]:Up/Down [ENTER]:Enter 4 OPTION MENU 2/2 . E)PARAM. INI F)ZONE SET G)XM RADIO SET H)DOCK SET [ ]/[ ]:Up/Down [ENTER]:Enter p p p ■ Display settings A)DISPLAY SET Note Use the "V-RESET" in "ADVANCED SETUP" to set the parameters in "DISPLAY SET" (except "DIMMER", "SHORT MESSAGE", "ON SCREEN" and "FL SCROLL") to the factory presets (see page 119). A)DISPLAY SET . DIMMER;;;;;;;;;;0 OSD SHIFT;;;;;;;0 GRAY BACK;;;;AUTO V CONV.;;;;;;;;ON [ ]/[ ]:Up/Down [p]/[[]:Adjust Dimmer DIMMER Use this feature to adjust the brightness of the front panel display. Control range: - 4 to 0 Control step: 1 • Press l to make the front panel display dimmer. • Press h to make the front panel display brighter. OSD shift OSD SHIFT Use this feature to adjust the vertical position of the OSD. Control range: -5 (upward) to +5 (downward) Control step: 1 Initial setting: 0 • Press l to raise the position of the OSD. • Press h to lower the position of the OSD. CUSTOMIZING THIS UNIT (MANUAL SETUP) Gray back GRAY BACK Use this feature to display a gray background in your video monitor when there is no video signal being input. Choices: AUTO, OFF • Select "AUTO" to display a gray background in your video monitor when there is no video signal being input. • Select "OFF" not to display a gray background in your video monitor. Notes • Depending on the video signals being input or the system setting of your video monitor (NTSC or PAL), the OSD may be displayed abnormally. In such cases, set "GRAY BACK" to "OFF". • Even when "GRAY BACK" is set to "OFF", the OSD may not be displayed correctly depending on the conditions of the picture. Video conversion V CONV. Use this feature to set whether to convert the video signals input at the VIDEO, S VIDEO and COMPONENT VIDEO jacks. Choices: ON, OFF • Select "ON" to convert composite, S-video and component video signals interchangeably and upconvert composite and S-video and component video signals to HDMI video signals. • Select "OFF" not to convert any signals. Notes • This unit does not convert 480 line video signals and 576 line video signals interchangeably. • The analog component video signals with 480i (NTSC)/576i (PAL) of resolution are converted to the s-video or composite video signals and output at the S VIDEO MONITOR OUT and VIDEO MONITOR OUT jacks. • The converted video signals are only output at the MONITOR OUT jacks. When recording a video source, you must make the same type of video connections between each component. • When composite video or S-video signals from a VCR are converted to component video signals, the picture quality may suffer depending on your VCR. • Set "V CONV." to "ON" to display the sound field parameter display and short message display. • Unconventional signals input at the composite video or S-video jacks cannot be converted or may be output abnormally. In such cases, set "V CONV." to "OFF". • When non-standard video signals (such as video signals from a game console) are input, this unit may not convert the signals even if you set "V CONV." to "ON". 97 En