Yamaha RX V1700 MCXSP10 Manual - Page 19
Connecting the speaker cable, SURROUND BACK terminals
UPC - 027108926186
View all Yamaha RX V1700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
PREPARATION FRONT terminals Connect front left and right speakers to these terminals. CENTER terminals Connect a center speaker to these terminals. SURROUND terminals Connect surround left and right speakers to these terminals. SURROUND BACK terminals Connect surround back left and right speakers to these terminals. Note When you use a surround back speaker, connect the speaker to the left SURROUND BACK terminal (SINGLE). PRESENCE terminals Connect presence left and right speakers to these terminals. SUBWOOFER jack Connect a subwoofer with a built-in amplifier (such as the YAMAHA Active Servo Processing Subwoofer System) to this jack. CONNECTIONS ■ Connecting the speaker cable 1 Remove approximately 10 mm (0.4 in) of insulation from the end of each speaker cable and then twist the exposed wires of the cable together to prevent short circuits. 10 mm (0.4 in) 2 Loosen the knob using the supplied speaker terminal wrench. Speaker terminal wrench Red: positive (+) Black: negative (-) 3 Insert one bare wire into the hole on the side of each terminal. 4 Tighten the knob to secure the wire using the supplied speaker terminal wrench. 15 En