Yamaha RX V1700 MCXSP10 Manual - Page 55
Adjusting the speaker level, Enjoying multi-channel sources in 2-channel stereo
UPC - 027108926186
View all Yamaha RX V1700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
BASIC OPERATION USING AUDIO FEATURES Adjusting the speaker level You can adjust the output level of each speaker while listening to a music source. This is also possible when playing sources input at the MULTI CH INPUT jacks. Note This operation will override the level adjustments made in "AUTO SETUP" (see page 32) and "SP LEVEL" (see page 90). 1 Set the operation mode selector to AMP and then press LEVEL on the remote control repeatedly to select the speaker you want to adjust. AMP SOURCE TV LEVEL TITLE BAND Enjoying multi-channel sources in 2-channel stereo You can mix down multi-channel sources to 2 channels and enjoy playback in 2-channel stereo. 1 Set the operation mode to AMP and then press STEREO on the remote control repeatedly to select "2ch Stereo". AMP SOURCE TV STEREO 5 2ch Stereo Display Adjusted speaker FRONT L Front left speaker CENTER Center speaker FRONT R Front right speaker SUR. R Surround right speaker SB L Surround back right speaker SB R Surround back left speaker SUR. L Surround left speaker SWFR Subwoofer PRNS L Presence left speaker PRNS R Presence right speaker y • Once you press LEVEL on the remote control, you can also select the speaker by pressing k / n. • Instead of "SB R" and "SB L", "SB" is displayed if "SUR. B L/R SP" is set to either "SMLx1" or "LRGx1" (see page 89). 2 Press l / h on the remote control to adjust the speaker output level. • Press i to increase the value. • Press j to decrease the value. Control range: -10 dB to +10 dB PRESET/CH A-E/CAT. ENTER y • You can use a subwoofer with this program when "LFE/BASS OUT" is set to "SWFR" or "BOTH" (see page 87). • You can also select the "2ch Stereo" mode by rotating the PROGRAM selector on the front panel. 2 Press PARAMETER and then l / h to set the "DIRECT" parameter. PRESET/CH PARAMETER DISPLAY A-E/CAT. ENTER Choices: AUTO, OFF • Select "AUTO" to bypass the decoders, DSP processors and the tone control circuitry only when "BASS" and "TREBLE" are set to 0 dB (see page 50). • Select "OFF" not to bypass the decoders, DSP processors and the tone control circuitry when "BASS" and "TREBLE" are set to 0 dB. y • When multi-channel signals (Dolby Digital and DTS) are input, they are downmixed to 2 channels and output from the front left and right speakers. • The low-frequency signals input from the front left and right speakers are redirected to the subwoofer in the following cases: -"LFE/BASS OUT" is set to "BOTH" (see page 87). -"FRONT SP" is set to "SMALL" (see page 88) and "LFE/BASS OUT" is set to "SWFR" (see page 87). • Press PARAMETER again to exit from the parameter setting mode. 51 En