Yamaha RX V1700 MCXSP10 Manual - Page 119

y • You must complete this step within 5 seconds while the selected zone flashes in the front panel display. Otherwise, the currently selected zone mode is automatically canceled. In this case, press ZONE CONTROLS again. • The initial setting is ZONE2 when both Zone 2 and Zone 3 are turned on. 3 Refer to "Selecting the input source of Zone 2 or Zone 3", "Adjusting the volume level of Zone 2 or Zone 3", "Adjusting the balance of the speaker level in Zone 2 or Zone 3" or "Adjusting the tonal quality of Zone 2 or Zone 3" on page 116 to perform further operations. Remote control operations 1 Set the operation mode selector to AMP and then press SELECT k repeatedly to select the zone you want to control. "ZONE 2" or "ZONE 3" is displayed in the display window on the remote control. AMP SOURCE TV SELECT USING MULTI-ZONE CONFIGURATION ■ Turning on or off Zone 2 and/or Zone 3 using the remote control POWER and STANDBY on the remote control work differently depending on the selected zone that appears in the display window on the remote control. • When the main zone, Zone 2 or Zone 3 mode is selected , you can turn on the main zone, Zone 2 or Zone 3 or set them to the standby mode individually. • When the all mode is selected, pressing POWER turns on the main zone, Zone 2 and Zone 3 simultaneously and pressing STANDBY sets them to the standby mode simultaneously. Control mode Display window POWER and STANDBY Main zone mode Name of the selected input area Turns on the main zone only or sets it to the standby mode. "ZONE 2" or "2;name Turns on Zone 2 or Zone 2 mode of the selected input sets it to the standby area" mode. "ZONE 3" or "3;name Turns on Zone 3 or Zone 3 mode of the selected input sets it to the standby area" mode. All mode "ALL" POWER: turns on the main zone, Zone 2 and Zone 3. STANDBY: sets the main zone, Zone 2 and Zone 3 to the standby mode. or 2 Refer to "Selecting the input source of Zone 2 or Zone 3", "Adjusting the volume level of Zone 2 or Zone 3", "Adjusting the balance of the speaker level in Zone 2 or Zone 3" or "Adjusting the tonal quality of Zone 2 or Zone 3" on page 116 to perform further operations. 3 Press SELECT k / n to exit from the Zone 2/Zone 3 mode. Note The input source of Zone 2 and the source available for recording are always the same. Notes • When the remote control is in the main zone mode, "MAIN" appears for a few seconds when POWER or STANDBY is pressed. • "ALL" appears in the display window on the remote control only when SELECT n is pressed. ■ Selecting the input source of Zone 2 or Zone 3 Rotate the INPUT selector on the front panel (or set the operation mode selector to AMP and then press one of the input selector buttons on the remote control) to select the input source of the selected zone. If the remote control is used to select the input source, "2: name of the selected input source" or "3: name of the selected input source" is displayed in the display window on the remote control when Zone 2 or Zone 3 is selected respectively. ADVANCED OPERATION 115 En