Yamaha RX V1700 MCXSP10 Manual - Page 113

■ Programming macro operations You can program your own macro and use the macro programming feature to transmit several remote control commands in sequence at the press of a button. Be sure to set up remote control codes or perform learning operations before programming the macro. Notes • The default macro is not cleared when a new macro is programmed for a button. The default macro can be used again when the programmed macro is cleared. • It is not possible to add a new signal (macro step) to the default macro. Programming a macro changes all macro contents. • We do not recommend programming continuous operations such as volume control in a macro. 1 Set the operation mode selector to AMP or SOURCE and then press MACRO using a ballpoint pen or similar object. "MCR ?" appears in the display window on the remote control. AMP SOURCE TV or AMP SOURCE TV MACRO REMOTE CONTROL FEATURES Note "AGAIN" appears in the display window if you press a button other than a macro button. 3 Press the buttons for the functions you want to include in the macro operation in sequence. You can set up to 10 steps (10 functions). After you have set 10 steps, "FULL" appears and the remote control automatically exits the macro mode. The following example is for programming the following procedure: Step 1 ("MCR 1"): Press DVD. Step 2 ("MCR 2"): Press AV POWER. Step 3 ("MCR 3"): Press SLEEP. POWER TV POWER AV STANDBY POWER XM 2AUDIO SEL SLEEP PHONO TUNER CD 3 MULTI CH IN V-AUX/DOCK CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR 2 DVD 1 (U.S.A. model) MCR 2: AV POWER MCR 3: SLEEP MCR 1: DVD Indicates the number of macro steps entered Note If you do not complete each of the following steps within 30 seconds, the macro programming mode will be automatically canceled. In this case, start over from step 1. Flashes alternately so you can set the next step 2 Press the macro button you want to use to operate the macro. The macro button name (ex. "M;DVD") and the selected component name (ex. "DVD") appear alternately in the display window on the remote control. STANDBY POWER XM PHONO TUNER CD MULTI CH IN V-AUX/DOCK CBL/SAT MD/TAPE CD-R Note To change the selected input area, press SELECT k / n. Pressing the input selector buttons will program a macro step, whereas SELECT k / n only changes the selected input area. 4 Press MACRO again using a ballpoint pen or similar object when the operation sequence you want to program is complete. Note "ERROR" appears in the display window if you press more than one button simultaneously. DTV VCR 1 DVR/VCR 2 DVD (U.S.A. model) ADVANCED OPERATION 109 En