Yamaha RX V1700 MCXSP10 Manual - Page 110
Changing source names in the display window, Set the operation mode selector to AMP or
UPC - 027108926186
View all Yamaha RX V1700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
REMOTE CONTROL FEATURES 5 Press and hold the button you want to program on the other remote control until "OK" appears in the display window on the remote control. "NG" appears in the display window on the remote control if learning was unsuccessful. In this case, start over from step 4. POWER TV XM PHONO TUNER POWER AV V-AUX/DOCK CBL/SAT MD/TAPE CD-R DTV STANDBY AUDIO SEL SLEEP CD VCR 1 DVR/VCR 2 DVD POWER MULTI CH IN SELECT (U.S.A. model) Other remote control y • If you want to program another function, repeat steps 4 and 5. • If you continuously want to program another function for another component, press SELECT k / n to select the component, and then repeat steps 4 and 5. 6 Press LEARN again to exit the learning mode. Changing source names in the display window You can change the name of the input source that appears in the display window on the remote control if you want to use a different name than the factory preset. This feature is useful when you have set an input area to control a different component. 1 Set the operation mode selector to AMP or SOURCE and then press an input selector button or to select the input area you want to rename. The name of the selected input area appears in the display window. AMP XM SOURCE TV PHONO TUNER CD MULTI CH IN or AMP SOURCE V-AUX/DOCK CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR 2 DVD TV (U.S.A. model) LEARN Notes • "ERROR" appears in the display window on the remote control if you press a button not indicated in the respective step, or when you press more than one button simultaneously. • This remote control can learn approximately 200 functions. However, depending on the signals learned, "FULL" may appear in the display before you program 200 functions. In this case, clear unnecessary programmed functions to make room for further learning. • Learning may not be possible in the following cases: - when the batteries in the remote control for this unit or other components are weak. - when the distance between the two remote controls is too great or too small. - when the remote control infrared windows are not facing each other at the appropriate angle. - when the remote control is exposed to direct sunlight. - when the function to be programmed is continuous or uncommon. 2 Press RENAME using a ballpoint pen or similar object. RENAME Note If you do not complete each of the following steps within 30 seconds, the renaming mode will be automatically canceled. In this case, start over from 2. 106 En