Yamaha YSP 4000 Owner's Manual - Page 36
SETUP, Getting started, Installing batteries in the remote control - installation
UPC - 027108928760
View all Yamaha YSP 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
GETTING STARTED Getting started Installing batteries in the remote control y Remove the transparent sheet before using the remote control. Press 1 Press and hold the mark on the battery cover and then open the cover. Operation range of the remote control The remote control transmits a directional infrared beam. Use the remote control within 6 m (20 ft) of this unit and point it toward the remote control sensor of this unit during operation. 2 Insert the two supplied batteries (AA, R6, UM-3) into the battery compartment. Make sure you insert the batteries according to the polarity markings (+/-). 3 Close the battery cover. AUX 3 INTELLIBEAM MIC Approximately 6 m (20 ft) 45 INPUT VOLUME + STANDBY/ON 45 Notes • Change all of the batteries if you notice the following conditions: the operation range of the remote control decreases or the transmission indicator does not light up or becomes dim. • Do not use old batteries together with new ones. • Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color. • Exhausted batteries may leak. If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. • Do not throw away batteries with general house waste. Dispose of them correctly in accordance with your local regulations. • The memory stored in the remote control may be erased in the following cases: - The remote control is left without batteries for more than two minutes. - Exhausted batteries remain in the remote control. - The buttons on the remote control are accidentally pressed when you change batteries. • If the memory stored in the remote control is unwantedly erased, insert new batteries and set the remote control codes again. Notes • Do not spill water or other liquids on the remote control. • Do not drop the remote control. • Do not leave or store the remote control in the following places: - places of high humidity, such as near a bath - places of high temperatures, such as near a heater or a stove - places of extremely low temperatures - dusty places • Do not expose the remote control sensor of this unit to direct sunlight or lighting such as inverted fluorescent lamps. • If the batteries grow old, the effective operation range of the remote control decreases considerably. If this happens, replace the batteries with two new ones as soon as possible. 32 En