Yamaha YSP 4000 Owner's Manual - Page 67

PLAYING BACK SOUND CLEARLY (MY BEAM) Playing back sound clearly (My Beam) You can improve listenability in a noisy environment by changing the beam mode to My Beam, which outputs sound beams directly toward the listening position in a single channel. In addition, My Beam is also ideal when you do not want the sound beams to be reflected on the walls in your listening room or when you do not want to disturb other people while enjoying music or movies at night. My Beam microphone STANDBY/ON VOL MODE POWER POWER AV TV INPUTMODE SLEEP 5BEAM 1 ST+3BEAM 2 3BEAM 3 STEREO 4 MY BEAM 5 MY SUR. 6 MUSIC 7 MOVIE 8 SPORTS 9 OFF SUR. DECODE 0 +10 ENHANCER ENTRY MENU CAT/ A-E DISPLAY ENTER TV/AV YSP RETURN (U.S.A. and Canada models) Note If My Beam is selected as the beam mode, the surround modes (see page 58), the CINEMA DSP programs (see page 65), and TruBass (see page 84) become ineffective. In addition, no audio is output from the subwoofer connected to this unit. Using auto-adjust function The My Beam microphone on the remote control collects the test tones from this unit so that the beam angle can be automatically adjusted. 1 Set the operation mode selector to YSP. TV/AV YSP 2 Press and hold MY BEAM for more than two seconds. A test tone is output twice from this unit. Keep pointing the remote control toward this unit while the test tones are being output so that the My Beam microphone can collect the test tones. Control range: L60° to R60° Operation guarantee range: 6 m (20 ft), L45° to R45° Notes • If an error occurs, an error buzzer is played and "MY BEAM ERROR" is displayed in the front panel display. • An error may occur if the listening room is noisy. Make sure that the listening room is as quiet as possible while the test tones are being output. • Do not shake or move the remote control while the test tones are being output. • Do not cover the My Beam microphone on the remote control while the test tones are being output. • The batteries in the remote control may be weak if the remote control does not function properly. In this case, replace all the batteries and then try the procedure again. • When the input signal with 64 kHz or 96 kHz of sampling frequency is being played back, the beam angle cannot be automatically adjusted. MY BEAM 5 BASIC OPERATION English 63 En