Yamaha YSP 4000 Owner's Manual - Page 83

• Select ANGLE TO WALL OR CORNER if this unit is installed in the corner of your listening room. Adjust the width and length of your listening room as well as the distance of the listening position from this unit. Listening position from the unit MANUAL SETUP INSTALLED HEIGHT (Installed height of this unit) Use to adjust the installed height of this unit. Choices: 0.0 m to 3.0 m Initial setting: 1.0 m Room width Room length Choices for the room width and length: 2.0 m to 12.0 m (6.5 ft to 40.0 ft) Choices for the listening position from this unit: 1.8 m to 9.0 m (6.0 ft to 30.0 ft) Room width and length p p A)SETTING PARAMETERS 2/3 ----- 5.4m --- | [ 5.4m ] | | p [ ]/[ ]:Up/Down [ ]/[ ]:Sel [ENTER]:Return p p Listening position from the unit p p A)SETTING PARAMETERS 3/3 \ [ 2.5m ] \ p [ ]/[ ]:Up/Down [ ]/[ ]:Sel [ENTER]:Return Note When you set the INSTALLED POSITION parameter in MANUAL SETUP (see page 78), the parameters newly set for the width and length of your listening room are automatically set as the factory default value. Floor 0.0 m to 3.0 m ■ BEAM ADJUSTMENT (Beam adjustment) Use to manually adjust the various sound beam settings. We recommend that you select 5 Beam as the beam mode before adjusting these parameters (see page 56). Notes • When INSTALLED POSITION is adjusted in MANUAL SETUP (see page 78), the factory default value is automatically set for this parameter except Center in FOCAL LENGTH (see page 81). • Depending on the beam mode settings (see pages 56 and 62), some channel positions may not be available for selection. In this case, "- -" is displayed. When using Stereo plus 3 Beam as the beam mode, set the surround left and right signals to be output from the front left and right channels. B)BEAM ADJUSTMENT . a)HORIZONTAL ANGLE b)VERTICAL ANGLE c)BEAM TRAVEL LENGTH d)FOCAL LENGTH e)TREBLE GAIN [ ]/[ ]:Up/Down [ENTER]:Enter p p ADVANCED OPERATION English 79 En