3Com 3C10200 NBX Installation Guide - Page 189
Low-bandwidth Telephony, In the Audio Compression Settings, make sure
View all 3Com 3C10200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
Configuring IP Telephony 189 Low-bandwidth Telephony To support remote users, you can configure a 3Com Telephone to operate over a low-bandwidth link. For reliable audio, the link must support throughput of at least 64 Kbps. An example is a single B channel of a Basic Rate Interface (BRI) ISDN line or a single channel on a T1 line. An ISDN connection is not the only method of connecting a remote telephone. The ability of NBX systems to operate in Ethernet (Layer 2) mode or IP (Layer 3) mode gives you several connection options such as cable modem, frame relay, and DSL. Your 3Com NBX Voice-Authorized Partner can help you to design a system to meet your needs. You enable low-bandwidth communications in an NBX system at the device level using the NBX NetSet utility. To enable low-bandwidth communication for a telephone: 1 Log in to the NBX NetSet utility using the administrator name and password. 2 Click Telephone Configuration > Telephones. 3 Select the telephone from the list by clicking its extension. 4 When the Modify page opens, enable these check boxes: ■ Disable Line Appearance/BLF ■ Disable Conferencing ■ Disable Paging Output ■ Disable Periodic Status Message Disabling these features reduces the network traffic, but the low-bandwidth telephone cannot play music on hold, initiate a page or participate in conference calls. 5 In the Audio Compression Settings, make sure Lowest Bandwidth Utilization is selected. The rest of the configuration is done at the telephone and at the router. At the telephone, you specify the IP address of the NCP. See "Manually Configuring Telephone IP Settings" on page 185. When your low-bandwidth link is operational and connected to the NCP, the Auto Discover process can discover and configure the telephone, or you can manually configure it through the NBX NetSet utility. You can operate with the link "always open" or you can set it up to autodial. With an autodial connection, when you lift the receiver on the telephone, the ISDN router or terminal adapter establishes the link to the