3Com 5500G-EI Command Reference Guide - Page 105
ip address, Syntax, Parameters, Description, VLAN Interface view - router
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
IP Address Configuration Commands 105 The Maximum Transmit Unit : 1500 bytes input packets : 0, bytes : 0, multicasts : 0 output packets : 0, bytes : 0, multicasts : 0 TTL invalid packet number: 0 ICMP packet input number: 0 Echo reply: 0 Unreachable: 0 Source quench: 0 Routing redirect: 0 Echo request: 0 Router advert: 0 Router solicit: 0 Time exceed: 0 IP header bad: 0 Timestamp request: 0 Timestamp reply: 0 Information request: 0 Information reply: 0 Netmask request: 0 Netmask reply: 0 Unknown type: 0 DHCP packet deal mode: global ip address Syntax ip address ip_address { mask | mask_length } [ sub ] [ undo ] ip address [ ip-address { mask | mask_length } [ sub ] ] View VLAN Interface view Parameters ip_address Enter the IP address of the VLAN interface. mask Enter the IP subnet mask of the VLAN interface. mask_length Enter the IP mask length of the VLAN interface. sub Enter if the specified IP address and subnet mask are a secondary IP address and subnet mask for this VLAN interface. Description Use the ip address ip_address mask command to configure the primary IP address and IP subnet mask for a VLAN interface. Use the ip address ip_address mask sub command to configure a secondary address and IP subnet mask for a VLAN interface. Usually, only one IP address is required for each interface. If you want to connect the interface to several subnets, you can configure an IP addresses for each subnet. Use the undo ip address ip_address mask sub command to cancel a secondary IP address and IP subnet mask of a VLAN interface.